Use and Care Guide

6
How to Hang Your Ceiling Fan
Figure 1
1. Securely attach the ceiling junction box acceptable
for ceiling fan support into the building structure.
Junction box is not supplied with the fan. (Figure 2)
2. Remove the three screws from the ceiling bracket
assembly and retain for later. (Figure 3)
3. Using the ceiling junction box screws and washer
provided with the ceiling junction box, securely attach
the ceiling bracket to the ceiling junction box as shown.
(Figure 4)
4. Hang the motor assembly from the ceiling bracket
assembly using the hook on the ceiling bracket
assembly and the cable loop from the motor assembly
as shown. (Figure 5)
You can now proceed with the electrical wiring of
your fan.
Figure 2
Floor
Ceiling
No
less than
7 ft
NOTE: Supply wires
omitted for clarity
Outlet Box
WARNING
It is critical that the outlet box and the screws are
securely anchored to the building structure and capable
of withstanding a load of at least 35 lbs. Failure to verify
that the screws are properly installed could result in the
fan falling. (Figure 2)
WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before hanging.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
The fan must be hung with at least 7´ of clearance from
floor to blades. (Figure 1)
Figure 3
Figure 4
Ceiling Bracket
Ceiling Bracket
Assembly
Assembly
Motor
Assembly
Figure 5
Junction Box
Screws (2)