Use and Care Guide

Downrod
Set Screw
Hanger Ball
How to Assemble Your Ceiling Fan
1. Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in the
hanger ball until the ball falls freely down the downrod.
Remove the pin from the downrod, then remove the
hanger ball. Retain the pin and hanger ball for reinstal-
lation in Step 6. (Figure 1)
2. Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
Hairpin
Clip
Clevis Pin
7
How to Assemble Your Ceiling Fan Blades
1. Disassemble the upper housing cover by removing
the six screws at the top of the motor assembly and
retain for Step 3. Carefully twist and lift
off the cover.
(Figure 1)
3. Reassemble the upper housing cover to the motor
assembly using the previously removed screws.
(Figure 3)
To reduce the risk of personal injury, do not bend the
NOTE: Periodically check blade hardware and
resecure if necessary.
2. Slide blades through slots in motor housing and attach
to the motor hub using the #8-32 washer head screws
and fiber washers. Make sure the screws securing the
blades to the motor hub are tight and are properly seated.
(
Figure 2)
blade when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in
between the rotating blades.
WARNING
!
Figure 2
#8-32 Washer Head Screw
with Fiber Washer
(3 per assembly)
Figure 1
Figure 2
Figure 3
HARDWARE USED:
x 15
x 15
FIBER WASHER
WASHER HEAD
SCREWS
#8-32
Upper Housing
Cover
Upper Housing
Cover
Motor Assembly
Motor Assembly
Blade
Figure 1