Use and Care Guide

How to Install Your Canopy Housing
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
NOTE: This step is applicable after the neccessary
wiring is completed.
Canopy Screw
Cover
Figure 2
Ceiling Canopy
Figure 1
11
How to Assemble Your Light Kit Assembly or Cap
1. Remove one of the three screws in the adaptor
plate at the bottom of the motor assembly. Slightly
loosen the remaining two screws. Assemble the light
kit assembly to the adaptor plate of the motor
assembly using the two key slots in the light kit
assembly. Replace the third screw and secure all
three screws. (Figure 1)
2. Remove the three screws in the light kit assembly.
Retain the screws for Step 4. (Figure 2)
Motor
Assembly
Figure 1
Figure 2
Light Kit
Assembly
Light Kit
Assembly
Connect the 2 single pin connectors from the LED
assembly to the 2 single pin connectors from motor
assembly. (Figure 3A)
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
CAUTION
3B. (Option B--for use with steel cap)
If you want to install the steel cap and not the light kit.
Assemble the steel cap to the light
kit
assembly by
twisting in a clockwise direction. (Figure 3B)
NOTE: If you have installed your fan with the steel
cap, skip Steps 4 and 5.
3A. (Option A--for use with light kit)
Figure 3A
Figure 3B
LED Assembly
Motor
Steel Cap
Light Kit Assembly