Installation Guide

Ceiling Bracket
Assembly
Motor
Assembly
Figure 2
How to Assemble the Ceiling Fan Blades
Figure 1
How to Assemble Your Ceiling Fan
8
Figure 1
3. Please remove the flexible bushing prior to pushing
the canopy trim ring up.
Push the canopy trim ring up to
conceal the screws, such that the mounting tabs seat
into the dimpled grooves in the ceiling bracket midway
between the screws. (Figure 3)
Ceiling Bracket
Assembly
Ceiling Bracket
Assembly
Motor
Assembly
Dimpled
Groove
Canopy Trim
Ring
Mounting
Tabs(4)
1. Mount your fan by sliding the motor assembly over
the mounting bracket with the two loosened screws
going into the “L” slots in the ceiling bracket. Be sure
all wiring is tucked into the motor housing and is not
pinched. Once the motor assembly is flush with your
ceiling, turn clockwise to seat the screws into the keyed
portion of the slot. Tighten the screws. (Figure 1)
“ L ” Slot
Screw
2. Assemble the motor assembly to ceiling bracket
using the previously removed screws and securely
tighten all screws. (Figure 2)
Figure 3
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
NOTE: Periodically check blade hardware and
resecure if necessary.
1. Slide blades through slots in motor housing and
attach to the motor hub using the #8-32 washer head
screws and fiber washers. Make sure the screws
securing the blades to the motor hub are tight and are
properly seated. (
Figure 1)
#8-32
Washer Head Screws
and Fiber Washer
(3 each per blade)
Blade
Motor
Assembly
x 9
x 9
FIBER WASHER
WASHER HEAD
SCREWS
HARDWARE USED:
#8-32