Use and Care Guide

How to Install Your Canopy Housing
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
NOTE: This step is applicable after the neccessary wiring is completed.
Canopy Screw
Cover
Figure 2
Ceiling Canopy
Figure 1
10
How to Assemble the Ceiling Fan Blades
HARDWARE USED:
x 15
x 15
FIBER WASHER
WASHER HEAD
SCREWS
3/16Ŋ-24
Figure 1
3/16Ý-24
Washer Head Screws
and Fiber Washer
(3 each per blade)
Blade
Blade Holder
1. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade holder.
:LWKDSKLOOLSVVFUHZGULYHUWLJKWHQÝZDVKHU
head screws and fiber washers to secure the blade
to the blade holder. (Figure 1)
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
NOTE: Periodically check blade holder hardware and
resecure if necessary.
2. Secure the blade holders to the bottom of the motor
assembly using the 1/4Ý-20 screws. (Figure 2)
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
WARNING
!
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
CAUTION
Blade Holder
Screws
(2 per assembly)
HARDWARE USED:
x 10
SCREWS
Figure 2