Use and Care Guide

12
How to Operate Your Ceiling Fan
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
WARNING
Figure 2
MAIN FUSE BOX
NOTE:
The fan's receiver features an automatic learning
function. There are no frequency switches on the receiver
unit. The receiver will automatically scan the frequency
from the hand held control if any changes are made.
The frequency settings should only be changed in the
case of interference or if multiple ceiling fans with the
same type of control system are installed in the same
structure.
1. IMPORTANT: Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
Figure 1
For illustrative purposes only-not
intended to cover all types of controls
Figure 4
3. To make fan operational, install 12-volt battery
(included in remote control package) into the remote.
(Figure 3)
CAUTION
If you are not expecting to use the remote for a long
period of time, remove the battery to prevent damage
to the remote. Be sure to store the remote away from
excess heat or humidity.
4. Follow these steps to pair your remote control to your
fan. (Figure 4)
12V 23A
Battery (1 pcs)
Figure 3
WARNING
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
1) When powering on your fan, do not press any
button(s) before pressing the “SET” button, otherwise it
will fail the learn procedure. If you press a button before
the “Set” button, please turn the power off then on again,
and start the process again.
2) Set the dip switches inside the battery compartment
door of the hand held transmitter to the desired setting.
3) After installing the unit and restoring power to your
fan, press and hold the “SET” button 1-5 seconds. You
must press the “SET” button within 60 seconds of
restoring power to the fan.
4) The fan will stir that mean your remote and fan has
synchronized. The fan is now ready for normal use.