Use and Care Guide

11
How to Install Your Canopy Housing
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
NOTE: This step is applicable after the neccessary wiring is completed.
Canopy Screw
Cover
How to Assemble Your Ceiling Fan Blades
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
CAUTION
CAUTION
Figure 2
Canopy
Figure 1
HARDWARE USED:
x 6
1/4Ŋ-20
SCREW
1/4Ý-20 Screw
(2 per assembly)
Figure 1
x 6
LOCK WASHER
Lock Washer
Flat Washer
x 6
FLAT WASHER
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
1. 6HFXUHWKHWKUHHEODGHVXVLQJWKHÝVFUHZV
with lock washers and flat washers through the holes
located on the bottom of the motor assembly.
(Figure 1)
Motor Assembly
Blade