Use and Care Guide

12
How to Assemble Your Light Kit Assembly
2. Connect the two single-pin connectors from the
socket plate assembly to the two single-pin
connectors from the motor assembly. (Figure 2)
4. Insert light bulbs into sockets. (Figure 4)
Motor Assembly
Figure 2
Socket Plate
Assembly
Socket Plate
Assembly
Socket Plate
Assembly
Bulb
Connecting Stud Assembly
Connecting Stud
Assembly
Motor
Assembly
Figure 1
Light Plate
Shade Assembly
Light Plate
Shade
Assembly
Figure 3
Figure 4
Figure 5
Figure 6
1. Remove one of the three screws inside the
adaptor plate at the bottom of the motor assembly.
Slightly loosen the remaining two screws.
Assemble the light plate shade assembly to the
adaptor plate of the motor assembly using the two
keyslots in the light plate shade assembly. Replace
the third screw and secure all three screws.
(Figure 1)
3. Remove one of the four screws inside the light
plate shade assembly. Slightly loosen the remaining
three screws. Assemble the socket plate assembly to
the light plate shade assembly using the three
keyslots in the socket plate assembly. Replace the
fourth screw and secure all four screws. (Figure 3)
5. Remove the nut from threaded stud on socket plate
assembly. Position glass onto the threaded stud of
socket plate assembly and secure with nut. Do not
overtighen. Twist and secure the connecting stud
assembly onto the threaded stud of socket plate
assembly. (Figure 5)
6. Remove the finial from connecting stud assembly.
Assemble the trim cover and trim ball onto to the
connecting stud assembly and secure with finial.
(Figure 6)
Glass
Nut
Trim Cover
Trim Ball
Finial