Use and Care Guide

4) The light will blink twice and fan stir that mean your
remote and fan has synchronized. The fan is now ready
for normal use.
13
How to Operate Your Ceiling Fan
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
WARNING
MAIN FUSE BOX
Figure 2
Figure 1
NOTE:
The fan's receiver features an automatic learning
function. There are no frequency switches on the receiver
unit. The receiver will automatically scan the frequency
from the hand held control if any changes are made.
The frequency settings should only be changed in the
case of interference or if multiple ceiling fans with the
same type of control system are installed in the same
structure.
3. To make fan operational, install 23A/12V battery
(included) in hand-held remote transmitter, with fan
power off. Then follow the remote code setting process.
(If not used for long periods of time, remove battery to
prevent damage to transmitter). Store the remote away
from excessive heat or humidly. (Figure 3)
4. Follow these steps to pair your remote
control to your fan. (Figure 4)
Figure 3
Figure 4
For illustrative purposes only-not
intended to cover all types of controls
1. IMPORTANT: Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
1) When powering on your fan, do not press any
button(s) before pressing the “SET” button, otherwise it
will fail the learn procedure. If you press a button before
the “Set” button, please turn the power off then on again,
and start the process again.
2) Set the dip switches inside the battery compartment
door of the hand held transmitter to the desired setting.
3) After installing the unit and restoring power to your
fan, press and hold the “SET” button 1-5 seconds. You
must press the “SET” button within 60 seconds of
restoring power to the fan.
WARNING
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.