Use and Care Guide

12
How to Assemble Your Light Kit
2. Remove one of the three screws in the light fitter
assembly and retain for later. Slightly loosen the
remaining two screws. Connect the two single pin
connectors from the socket plate assembly to the two
single pin connectors from the motor assembly.
(Figure 2)
4. Insert light bulb into socket. (Figure 4)
5. Securely attach glass by twisting clockwise onto
the light fitter assembly. Don’t overtighten or force it.
(Figure 5)
Motor Assembly
Figure 3
Socket Plate
Assembly
Socket Plate
Assembly
Bulb
Light Fitter
Assembly
Light Fitter
Assembly
1. Remove one of the three screws inside the
adaptor plate at the bottom of the motor assembly.
Slightly loosen the remaining two screws. Assemble
the light fitter assembly to the adaptor plate of the
motor assembly using the two keyslots in the light
fitter assembly. Replace the third screw and secure
all three screws. (Figure 1)
3. Assemble the socket plate assembly to the light
fitter assembly using the two key slots in the socket
plate assembly. Replace the third screw and secure
all three screws. (Figure 3)
Figure 2
Figure 5
Glass
Motor
Assembly
Figure 1
Light Fitter
Assembly
CAUTION
To reduce the risk of fire, use 100-watt max. type
T4-minican JD E11 tungsten halogen bulb. Turn off
the wall switch and allow the bulb to cool for 10
minutes before relamping.
Bulb is pressurized and may shatter. DO NOT
TOUCH BULB WITH BARE HANDS. Fingerprints
may result in shorter bulb life. Remove fingerprints
with alcohol prior to use.
Figure 4
Socket Plate
Assembly