Installation Guide

How to Assemble Your Light Kit
2. Remove one of the three screws in the light kit
assembly and retain for later. Slightly loosen the
remaining two screws. Connect the two single pin
connectors from the LED assembly to the two
single pin connectors from the motor assembly.
Assemble the LED assembly to the light kit
assembly using the two key slots. Replace the
removed screw and secure all three screws. (Figure 2)
3. Securely attach glass by twisting clockwise onto
the light kit assembly. Don’t overtighten or force it.
(Figure 3)
1. Remove one of the three screws inside the
adaptor plate at the bottom of the motor assembly.
Slightly loosen the remaining two screws. Assemble
the light kit assembly to the adaptor plate of the
motor assembly using the two keyslots in the light
kit assembly. Replace the third screw and secure
all three screws. (Figure 1)
To reduce the risk of personal injury, do not bend the
blade when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in
between the rotating blades.
WARNING
!
12
How to Assemble Your Ceiling Fan Blades
NOTE: Periodically check blade hardware and
resecure if necessary.
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
CAUTION
HARDWARE USED:
x 9
3/16
-24
Washer Head
Screw
Blade
Motor Assembly
Figure 1
x 9
FIBER WASHER
Washer Head Screw
with Fiber Washer
(3 per assembly)
1. Slide blades through slots in the motor assembly and
position over the threaded posts of the motor assembly.
Make sure the bottom edge of the blades are fully
seated against the flywheel of motor assembly. Tighten
washer-head screws with fiberwashers to secure the
blades to the threaded posts of motor assembly.
(Figure 1)
Light Kit
Assembly
Figure 2
Light Kit
Assembly
Figure 3
Glass
Motor
Assembly
Figure 1
LED Assembly
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
CAUTION