Installation Guide

How to Install Your Canopy Housing

Figure 1

2. Securely attach and tighten the canopy screw cover

over the shoulder screws in the hanger bracket utilizing

the keyslot twist-lock feature. (Figure 2)

NOTE: This step is applicable after the neccessary wiring

is completed.

Figure 2

Ceiling Canopy

Canopy Screw

Cover

WARNING

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the canopy

housing and not pinched between the housing and the

ceiling.

1. Assemble canopy by rotating key slot in canopy

over shoulder screw in hanger bracket. Tighten

shoulder screw. Fully assemble and tighten second

shoulder screw that was previously removed.

(Figure 1)

How to Assemble Your Light Kit

1. Remove one of the three screws in the support

bracket at the bottom of the motor assembly and retain

the screw for later and slightly loosen the remaining

two screws. (Figure 1)

To reduce the risk of electric shock, disconnect the

electrical supply circuit to the fan before installing

your light kit.

CAUTION

2. Assemble the light kit to the support bracket using

the two key slots in the light kit. Replace the previously

removed screw and securely tighten all three screws.

(Figure 2)

Light Kit

Figure 2

Motor Assembly

Figure 1