Installation Guide

4. Once the connection has been made, slide the

receiver into the hanger bracket, taking care not to

pinch the wires. (Figure 5)

Receiver

Hanger Bracket

How to Wire Your Ceiling Fan (continued)

Figure 5

Installing Your Canopy Housing

Figure 1

2. Securely attach and tighten the canopy screw cover

over the shoulder screws in the hanger bracket utilizing

the keyslot twist-lock feature. (Figure 2)

NOTE: This step is applicable after the neccessary wiring

is completed.

Figure 2

Ceiling Canopy

Canopy Screw

Motor Assembly

Cover

1. Remove one of the two shoulder screws in the

hanger bracket. Loosen the second shoulder screw

without fully removing it. Assemble canopy by

rotating key slot in canopy over shoulder screw in

hanger bracket. Tighten shoulder screw. Fully

assemble and tighten second shoulder screw that

was previously removed. (Figure 1)

WARNING

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the canopy

housing and not pinched between the housing and the

ceiling.

Figure 1

How to Assemble Your Light Kit

1. Remove one of the three screws in the support

bracket at the bottom of the motor assembly and retain

the screw for later and slightly loosen the remaining

two screws. (Figure 1)

To reduce the risk of electric shock, disconnect the

electrical supply circuit to the fan before installing

your light kit.

CAUTION