Installation Guide

How to Assemble Your Ceiling Fan
1. Slide blades through slots in motor housing and
attach to the motor hub using the 3/16”-24 washer
head screws and fiber washers. Make sure the
screws securing the blades to the motor hub are tight
and are properly seated. (Figure 1)
NOTE: Periodically check blade hardware and
resecure if necessary.
9
Figure 1
Ceiling Bracket
Assembly
Wide Notch
Wide Tab
Motor
Assembly
3/16”-24
Washer Head Screws
and Fiber Washers
(3 each per blade)
Blade
How to Assemble Your Ceiling Fan Blades
x 15
3/16”-24
Washer Head Screws
x 15Fiber Washers
HARDWARE USED:
Figure 1
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
CAUTION
Motor
Assembly
How to Assemble Your Light Kit or Cap
Figure 1
1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly. Retain
the screw for later and slightly loosen the remaining
two screws. (Figure 1)
1. Align the wide tab of motor assembly to the wide
notch of ceiling bracket. Carefully secure the motor
housing onto the mounting slots on ceiling bracket
by twisting in a clockwise direction. Be sure the
receiver and all wiring are tucked into the motor
housing and is not pinched. Once the motor assembly
is flush with your ceiling, replace the previously
removed screws and securely tighten all four screws.
(Figure 1)
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.