Installation Guide

7
Figure 2
Figure 3
Ceiling
Floor
No Less
Than
7 Feet
WARNING
The fan must be hung with at least 7´ of clearance
from floor to blades. (Figure 2)
WARNING
It is critical that the outlet box and the screws are
securely anchored to the building structure and
capable of withstanding a load of at least 35 lbs.
Failure to verify that the screws are properly installed
could result in the fan falling.
CAUTION
Do not connect fan blades until the fan is completely
installed. Hanging fan with blades connected may
result in damage to the fan blades.
1. Securely attach the outlet box acceptable for ceiling
fan support into the building structure. Outlet box is
not supplied with the fan. (Figure 3)
3. Using the outlet box screws provided with the outlet
box, securely attach the ceiling bracket assembly to
the outlet box as shown. (Figure 5)
2. Remove the four screws from the ceiling bracket
assembly and retain for later. (Figure 4)
Outlet Box
NOTE: Supply wires
omitted for clarity
NOTE: Supply wires
omitted for clarity
Outlet Box
Figure 5
Ceiling Bracket
Assembly
Ceiling Bracket
Assembly
Flat Washers (2)
Screws (2) Supplied
with Outlet Box
How to Hang Your Ceiling Fan (Continued)
4. Hang the motor assembly from the ceiling bracket
assembly using the hook on the ceiling bracket
assembly and the cable loop from the motor assembly
as shown. (Figure 6)
5. Make sure the electrical supply wires and the ceiling
bracket grounding wire are pulled through the center
hole of ceiling bracket, between the ceiling bracket
and the motor assembly so that electrical connections
can be made later.
Figure 6
Motor
Assembly
NOTE: Supply wires
omitted for clarity
NOTE: Supply wires
omitted for clarity
Figure 4
Ceiling Bracket
Assembly