User's Manual

Stop measurement
If there is any discomfort or for some reason, such as when the airbag is in a persistent over-inflated state, there may be a risk.
At this time, the blood pressure measurement must be stopped. You can press the [START/STOP] button and the Upper Arm
Blood Pressure Monitor will immediately release the air pressure in the cuff to suit your need.
2 Confirm measurement results
Automatic storage of measurement results. SYS
1) irregular pulse： DIA
PULSE
The unit can detect the arrhythmia. When this symbol appears after the measurement is completed, it may differ from your
normal blood pressure. Please measure it a few more times. If this symbol is displayed frequently, it is recommended that you
tell the doctor about this situation, and ask the doctor for frequent information on the irregular heartbeat indicator.
2) Error action prompt function:
The display represents speaking or moving during the measurement,
The measurement may not be correct. Please measure again.
3）Cuff wearing self-test prompt icon:
When the cuff is wrapped correctly, the screen displays
When the cuff is wrapped too loosely, the screen displays
Please press the [START/STOP] button to turn off the power, rewind the cuff correctly, and measure again
8.3 Removing the Arm Strap.
8.4 Automatic Shutdown
The number is displayed until the power is turned off (if you forget to turn off the
power, the monitor will automatically turn off after 30 seconds to save power).
Note: depending on the location, this product is available in mmHg or kPa display
mode, and can be used according to the selected display mode according to this
operating instructions.
9.View measurement results
The Upper Arm Blood Pressure Monitor can automatically record 120 measurements.If the measurement result is
remembered more than 120 times, the earlier measurement record will be deleted and the new measurement result will be recorded.
9.1 Check the memory