User's Manual

Unpack the box and lay the product flat on the table.
Note：If you bring the product from a storage environment, place it in a normal use
environment for 20 minutes
5.2 battery
If there is a signal of low power on the display, connect your charger.
Icon lit: Battery is low.
Lo icon lights up: battery is exhausted.
Please connect adapter to charge.
※ Do not use this product while charging. No measurement function during charging
Please pay attention!
Once the signal of low power is displayed, the product will not
be used unless you charge it.
Note:
• Consult the dealer at the place of purchase for any adapter problems.
5.3Use adapter
Except the battery, this unit can also use a adapter (USB 5V).Must use the original or medical power supplies that meet medical
standards.
(example: IEC 60601-1 certification). Transformer connects to power socket is shown on the following. Adaptor connects to the
power socket of the product and press the START/STOP/memory button to test if it is power.
If power failure suddenly during measurement (for example, adapter plug is disconnected to power outlet), adapter single-pin
plug should be unplugged and reinsert into the unit again.
Any problems about adapter, please consult purchased dealer locally.
6.Connect the cuff
The correct method of using the cuff: