User Instructions

AT+WLMACxxxxxxxxxxxx
（xxxxxxxxxxxxFor hexadecimal numbers）
failure：AT+ERR
HTTP_POST=x
xxxxxxxxxxxxx
x
(The x table is
the data)
Write
Send the data to the server（Return data）
example：AT+REN=FDIR8001 Module naming：FDIR8001
The above settings require power-off storage
Other requirements：
Account management：
1 、 Each module has a separate MAC address for later server account
management discrimination
2、OTA upgrade
3、 Information required in the broadcast: module name, device type,
service UUID (0xFEEF)
4 、When both BLE and WIFI are connected, if BLE is APP connection,
transfer data from BLE is preferred, if BLE is other connection (such
as network connection), select transmission from WIFI
5、WIFI Default name FD_WIFI,Bluetooth default name FD_BLE
data transmission ：
1、 Directive package length：
BLE：Short bag≤32 Byte，Long bag≤517 Byte；
WIFI：most 1460 Byte；
2、 Data transmission mechanism：
After the Bluetooth data transmission, more than 100ms did not
receive the data transmission to re-enter the low power
consumption state。
During the data transmission process, if the data is not received
within 20ms, no longer wait, and the data is sent directly, used
to judge each instruction node。
Burning configuration：
WIFI name, Bluetooth name, port rate。
Attached a： The MAC address information is as follows：
The MAC address should contain the content： XX XX XX XXXXXX
first XX：tatted code
the second XX：A high 4bit means year + 2015, for example a high four