Specifications

18
on the T6 key will activate remote binding mode. The T6 Key will flash for a maximum of 10
seconds. During flashing, at least one radio control key must be pressed. The function will
deactivate upon completion of the 10 seconds, or earlier if a compatible remote control is
detected.
Key pressure management:
Prolonged pressure = finger pressed on key for at least 3 seconds, the function activates
during pressure.
Non-prolonged pressure = finger pressed on key for less than 3 seconds, the function
activates upon its release.
Radio control (optional): Place the device far from sources of electromagnetic waves
which could interfere with the range hood’s electronic functions
Maximum operating distance 4 metres. This distance may vary in defect based on elec-
tromagnetic interference of other devices.
Function of the
remote control
DESCRIPTION
Light Key
Pressing the Light key will switch the light on/off
‘ - ‘ Key
Pressing the ‘-’ Key will decrease motor speed. If 1° (1st) speed is in gear, pressing
the ‘-’ key will turn off the motor
‘ + ‘ Key
If the motor is turned off, pressing the ‘+’ key will activate the motor at 1° (1st)
speed. If the motor is operating, pressing the ‘+’ key will increase motor speed up
to the maximum.
Timer Key
If the motor is active, pressing the timer key will activate/deactivate the timer
function
Code Change
(only in case of
malfunction)
Press the “Luce” (Light) key together with the “Timer” key of the remote control
until the blue LED begins to slowly flash. If the “-” key of the remote control
is pressed within 5 seconds, the new code will be generated and memorised.
Memorisation is confirmed by 3 brief flashes of the LED.
To return to the default code, apply pressure on the “-” key together with the “+”
key for over 5 seconds. Memorisation of the default code will be signalled with 3
brief flashes of the LED.
Each time that a new code is generated or that the default code is set in the
remote control, it is necessary to also carry out the previously described Remote
Binding (Light Key of the pushbutton) procedure.
FILTERS REMOVING AND REPLACING’S INSTRUCTIONS
H
1. METAL FILTERS
To remove the metal grease-trapping filter, simply pull the handle A until releasing it from
the front guide; then tilt it slightly downwards, and slide it out of the rear guide. To reposi-
tion the filter, repeat the operation in the reverse order.
Hoods with perimeter suction:
- Open the panel (see fig. 1). Use handle A to remove the metal grease filter.
A