Instructions

17
SAFETY WARNINGS
M
The electrical system features an earth connection in compliance with in-
ternational safety standards; furthermore, it is compliant with the European
standard for electromagnetic compatibility.
Do not connect the appliance to flues (from boilers, fireplaces, etc.). Make
sure the mains voltage corresponds to the values on the rating plate located
inside the range hood. The minimum safety distance between the cooktop and
the range hood must be at least 65 cm (25,6”).
Never cook on “open” flames under the range hood.
Check deep-fryers during use: superheated oil may be flammable.
- Ensure there is adequate ventilation of the room when the rangehood is
used at the same time as appliances burning gas or other fuels.
- Do not flambe under the rangehood
- The exhaust air must not be discharged into a flue which is used for exhaust-
ing fumes from appliances burning gas or other fuels.
- Ensure that all regulations concerning the discharge of exhaust air have
been fulfilled before you use the appliance.
Before performing any cleaning or maintenance operations, disconnect the ap-
pliance by unplugging it or using the main switch. The manufacturer disclaims
all liability for any damage that may be directly or indirectly caused to people,
things and animals due to the failure to follow all the instructions provided in
this booklet and above all the warnings relating to the installation, operation
and maintenance of the appliance.
WARRANTY
N
The new equipment is covered by warranty.
The warranty conditions are provided by the distributor.
The manufacturer is not liable for any inaccuracies in this booklet resulting
from printing or transcription errors. The manufacturer reserves the right to
modify its products as it considers necessary or in the interests of the user,
without compromising their essential safety and operating characteristics.
O
MOUNTING INSTRUCTIONS, RANGE
HOODS WITH BOX
INSTALLING THE INTERNAL RECIRCULATING HOOD (fig. O1)
Step 1
- Mount the air recirculation kit (specific for the hood to be installed) onto the
cabinet, using the screws provided (A).
- Check that the back output be closed by buffer BO1 and BO2.
Step 2
- Remove the hood’s metal filters as described in section H1.
- Install the carbon filters (F) as described in section H2.
- Mount the hood onto the recirculation kit that was previously installed, using