Instructions

through an exhaust duct.

The exhaust conveyor that protrudes from the upper part of the range hood

must be connected to a duct that carries the fumes and steam outside. In this

application, the charcoal filters, if fitted, should be removed; to do this, see the

instructions in point F. There must be adequate ventilation of the room when the

range hood is used at the same time as appliances burning gas or other fuels,

according to the standard.

Deviation for Germany:

When the range hood and appliances supplied with energy other than electric-

ity are simultaneously in operation, the negative pressure in the room must

not exceed 4 Pa (4x10 E-5 bar).

RECIRCULATING RANGE

HOOD (with filter)

In this application, the air passes through charcoal filters for purification, and is

then recirculated back into the kitchen.

Check that the charcoal filters are fitted to the motor, and if not, install them as

described in the instructions in point H.

If the hood is of filtering type, remove the non-return valve fitted at the motor’s

outlet.

For maximum efficiency, the third speed should be used when there are strong

odours or a lot of steam, the second speed in normal conditions, and the first

speed for keeping the air clean with minimum energy consumption. The range

hood should be switched on when starting to cook, and left on until the odours

disappear.

OPERATION

ELECTRONIC CONTROL PANEL

Light pushbutton

• ON: light on (the pushbutton is lit);

• OFF: light off;

Pushbutton -

Press to reduce motor speed

Speed 1, 2 and 3 are indicated by the number of LEDs that light up (exclud-

ing the light and the timer LEDs).

Pushbutton +

Press to increase motor speed

Speed 1, 2 and 3 are indicated by the number of LEDs that light up (exclud-

ing the light and the timer LEDs).

(In the 4-speed version the pushbutton + blinks. The fourth speed remains

on for a set duration of time. After 7 minutes the motor returns to the third

speed).

Mode pushbutton

Function: it turns hood motor on and off.

The function “desired speed” enables to start the motor at the speed that