User manual

100
Anhang/Appendix
EN
Szenario: Verkehrskreuzung mit Ampeln
HINWEIS: Sie können maximal 2 Ampeln an einem Anschluss anschließen.
Die Ampeln schalten abwechselnd (gegenläufig). Schalten die Ampeln auf
der Hauptstraße auf 'Gelb' werden die Stopp-Stellen auf der Hauptstraße
aktiviert und die Fahrzeuge angehalten. In diesem Zeitraum schaltet die
Ampel der Seitenstraße auf 'Grün'. Sobald die Ampeln auf der Hauptstraße
wieder auf 'Grün' umschalten, werden die Fahrzeuge freigegeben und die
Stopp-Stelle in der Seitenstraße aktiviert.
X
Schließen Sie die Komponenten an, siehe Abb. 37.
X
Regeln Sie die Dauer der Grünphase von Ampel 1 am Poti 1, siehe
Seite 9, Tab. 4.
X
Regeln Sie die Dauer der Grünphase von Ampel 2 am Poti 2, siehe
Seite 9, Tab. 4.
Die Ampeln sind angeschlossen und eingestellt.
Scenario: Traffic crossroads with traffic lights
ADVICE: Two traffic lights at most can be connected to one port.
The traffic lights operate alternately (contrary course). Whenever the traf-
fic lights on the main road switch to ‘Yellow’, the stop sections on the main
road are activated and the vehicles are stopped. During that time the traffic
lights on the by-road are in the green phase. As soon as the traffic lights on
the main road switch over to ‘Green’, the vehicles standing there are freed
and the stop section on the by-road is activated.
X
Connect the components, see Fig. 37.
X
Adjust the duration of the green phase of traffic lights 1 at Poti 1, see
page 47, Table 4.
X
Adjust the duration of the green phase of traffic lights 2 at Poti 2, see
page 47, Table 4.
The traffic lights are now connected and set.
DE