Operation Manual

Charging vehicles

Charging digital vehicles

ADVICE:

 The charging procedure may last up to two hours.

 The digital vehicle need not be discharged prior to the charging proce-

dure as the charging unit checks the voltage at the rechargeable battery

of the vehicle and adjusts the charging curve accordingly.

 Whenever a LED quickly ﬂashes while the charging unit is in operation,

this is a fault message. To remedy the fault, see Chapter 7 “How to deal

with problems”, page 35.

 If the rechargeable battery heats up to a temperature higher than that of

the hand during the charging procedure, immediately interrupt the pro-

cedure and send the vehicle to FALLER’s customer service department.

Prerequisite condition: the charging unit is connected.

Switch the vehicle off.

Fig. 4: Connecting the charging cable to the charging unit

ADVICE: When connecting the charging cable to the charging unit, make

sure you observe the polarity: the red mark on the charging cable must be

connected to the »+« port.

Insert the plug located at one end of the charging cable into the socket

of the charging unit, see Fig. 4.

Insert the plug located at the other end of the charging cable into the

socket located on the underside of the vehicle.

ADVICE: If, when switching the vehicle on, both LEDs »Car 2« and »voll«

start ﬂashing, this means that the ports of the plug have been inverted. In

such a case rotate the plug by 180°.