Manualshelf

Safety Data Sheets (SDS)

ManualsBrandsFalconPly ManualsBuilding materials3/4 x 4 x 8 B2 Natural Maple Wood Veneer Core Plywood
1234567
Hardwood Plywood
Safety Data Sheet
According To Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules And Regulations
EN (English US)
4/7
Exposure Controls
Appropriate Engineering Controls: Ensure all national/local regulations are observed. Proper grounding procedures to avoid static
electricity should be followed. Use explosion-proof equipment. Provide adequate ventilation to minimize dust concentrations.
Personal Protective Equipment: Dust formation: dust mask. In case of dust production: protective goggles. Gloves. Protective
clothing.
Materials for Protective Clothing: Not available
Hand Protection: Cloth gloves.
Eye Protection: In case of dust production: protective goggles.
Skin and Body Protection: Wear suitable protective clothing. Wash contaminated clothing before reuse.
Respiratory Protection: Use NIOSH-approved air-purifying or supplied-air respirator where airborne concentrations of dust are
expected to exceed exposure limits.
Other Information: When using, do not eat, drink or smoke.
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Information on Basic Physical and Chemical Properties
Physical State
:
Solid
Appearance
:
Not available
Odor
:
Slight wood odor
Odor Threshold
:
Not available
pH
:
Not available
Evaporation Rate
:
Not available
Melting Point
:
Not available
Freezing Point
:
Not available
Boiling Point
:
Not available
Flash Point
:
Not available
Auto-ignition Temperature
:
Not available
Decomposition Temperature
:
Not available
Flammability (solid, gas)
:
Not available
Lower Flammable Limit
:
Not available
Upper Flammable Limit
:
Not available
Vapor Pressure
:
Not available
Relative Vapor Density at 20 °C
:
Not available
Relative Density
:
Not available
Specific Gravity
:
Not available
Solubility
:
Insoluble.
Partition Coefficient: N-Octanol/Water
:
Not available
Viscosity
:
Not available
Explosion Data – Sensitivity to Mechanical Impact
:
Not expected to present an explosion hazard due to mechanical impact.
Explosion Data – Sensitivity to Static Discharge
:
Take precautions against static discharge where there is a risk of dust
explosion.