T Series Specification

How to Order
For correct ordering, and to ensure no delays in shipment of
your order, the following descriptive data must be listed in the
sequence shown. Necessary information can be found in other
parts of this catalog. The example below shows an order for 12
each T locksets in the 571 Dormitory function, D (Dane) trim
design in a 626 (satin chrome) nish, with 2-3/4” backset latch,
to accommodate doors 1-3/4” thick.
Quantity: Indicate the quantity required.
Catalog Number: Select function number, cylinder type, and
latch style from tables in this section.
Trim Design: Indicate letter of lever design required. Example:
AVA=Avalon; DAN=Dane; QUA=Quantum.
Finish: When the nish is the same for the outside and inside
trim, it is shown once (626). For split nishes, the outside is
designated rst, then the inside (605 x 625).
Latches: 2-3/4” backset is standard. Adjustable front standard.
A Grade 2 latch with a 1” faceplate in 2-3/8” and 2-3/4” backset
Finishes
The latest in modern techniques and equipment are used to apply
the highest quality nish. Extra steps assure durable, consistent
nishes and long useful life.
Although we apply the nest available protective plating and/or
enamel coating to the surface of our products, these nishes have
limitations and in time may deteriorate either from exposure to
weather, pollution, perspiration, extremes of climate, frequency of
Trim Finishes Chart
Description ANSI No. Available on
Bright Brass 605 All Trim
Satin Brass 606 All Trim
Satin Bronze 612 All Trim
Satin Bronze Oil Rubbed 613 All Trim
Bright Chrome 625 All Trim
Satin Chrome 626 All Trim
also available. See page 10. All latches are UL listed 3 Hour.
Strikes: 4-7/8” x 1-1/4” ANSI standard. Optional T-Strike or
Full Lip strike available. See page 11.
Cylinder Type: 6 pin is standard. For 7-pin add PD7 to product
catalog numbers (eg. T501PD7 QUA).
Keying Detail: We suggest using the standard terms developed
by DHI (Door and Hardware Institute) or ALOA (Associated
Locksmiths of America Inc.)
Example: AA1 - Grand Master keyed, Master keyed, change
key 1.
Interchangeable Core: Interchangeable core: To order product
capable of accepting an interchangeable core, add sufces from
the keying table to the function number, preceding the latch
style. Example: T511JD will be supplied with a FSIC prepped
lever to accept a competitor full size interchangeable core.
Keyways: “G” is standard on regular cylinders, “A” is standard
on interchangeable cores. Other keyways available. See current
pricebook.
use or other factors. Deterioration of these nishes is, therefore,
not a defect, but a normal process which is unavoidable. Our
company cannot accept responsibility for nish deterioration in
these circumstances; therefore, the nishes cannot be guaranteed.
These products will not be renished or replaced under our
warranty should deterioration of nishes occur.
How to Order Example
T S E R I E S
G E N E R A L I N F O R M AT I O N
Line Item Qty. Product Outside Inside Hand Latch Strike
Door
Thickness
Ext. DIM
Additional
Details/Keying
DES FIN DES FIN
1 20 T571JD DAN 626 98535 5164 1-3/4” With 012191-003-70
dust box. FSIC prep IC-YA6
15