User's Manual
Table Of Contents
- U111301 cover - Falcon
- U111301-01 [AUS]
- 1. Before you start...
- 2. Cooker Overview
- 3. Rotary clock
- 4. Cooking Tips
- 5. Cooking Table
- 6. Cleaning Your Cooker
- 7. Troubleshooting
- 8. Service and Spares
- 9. Installation
- Safety Requirements and Regulations
- Provision of Ventilation
- Location of Cooker
- Conversion
- Positioning the Cooker
- Moving the Cooker
- Completing the Move
- Levelling the Cooker
- Fitting the Stability Bracket and Chain
- Repositioning the Cooker Following Connection
- Conversion to Another Gas
- Gas Connection
- Natural Gas
- Propane
- Pressure Testing
- Electrical Connection
- Connection in New Zealand
- Final Checks
- Customer Care
- Fitting the drawer
- Removing the drawer
- 10. Conversion to Propane Gas
- 11. Servicing
- 12. Circuit Diagram
- 13. Technical Data
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have nished.
35
Set the Governor
Unscrew the governor’s brass top. In the base of the brass top
is a plastic snap-in converter device (Fig. 10.4). To convert the
governor, snap the device out of the top and ret it the other
way round. The snap-in converter device is marked to show
the gas for which it is set (Fig. 10.5).
Make sure the device is secure in the top cap and ret the cap
to the governor.
Pressure Testing
The pressure test point is accessible on the inlet pipe at the
rear. Remove the test nipple screw and t a pressure gauge to
the test point. Turn on and light two of the hotplate burners.
For Propane X cookers the pressure should be 2.54 kPa.
n
Make sure that the appliance is gas sound.
n
Check the operation of all the burners.
Affix Label
Stick the appropriate gas label over the natural gas part of the
appliance data label.
ArtNo.102-0007 - Maxitrol converter device positions
ArtNo.103-0006 - Maxitrol cap & converter
Nut
Snap-in converter device
Fig. 10.4
Fig. 10.5