Installation and Operation Guide
INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
26
Moving the Cooker
On no account try and move the cooker while it is
plugged into the electricity supply.
The cooker is very heavy, so take great care.
We recommend that two people manoeuvre the cooker.
Make sure that the oor covering is rmly xed, or removed,
to prevent it being disturbed when moving the cooker
around.
To help you, there are two levelling rollers at the back, and
two screw-down levelling feet at the front.
Remove the polystyrene base pack. From the front, tilt
the cooker backwards and remove the front half of the
polystyrene base (Fig.7-2). Repeat from the back and remove
the rear half of the polystyrene base.
Removing the Storage Drawer
Pull the drawer right out.
Push the ends of the plastic clips – down of the left-hand side,
up on the right-hand side – to release the catches holding the
drawer to the side rails (Fig.7-3). At the same time pull the
drawer forwards and away from the side rails.
For safety’s sake push the drawer rails back out of the way.
Removing the Oven Door
To remove the oven door, open the door fully. Swivel the
locking ‘U’ clips forward to the locking position (Fig.7-4). Grip
the sides of the door, lift upwards and then slide the door
forwards (Fig.7-5).
Lowering the Two Rear Rollers
To adjust the height of the rear of the cooker, rst t a 13 mm
spanner or socket wrench onto the hexagonal adjusting nut
(Fig.7-6).
Rotate the nut – clockwise to raise – counter-clockwise to
lower. Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.
Completing the Move
Unfold the rear edge of the pack base tray. Grip the fascia
panel and lift the front of the cooker slightly.
Carefully push the cooker backwards o the pack base.
Remove the pack base. Position the cooker close to its nal
position, leaving just enough space to get behind it.
DO NOT use the control knobs to manoeuvre the
cooker.
ArtNo.325-0002 - BI oven removing the door
Fig.7-5
Fig.7-3
ArtNo.062-0001 - 90 Prof+ FX - Removing the door
Fig.7-4
Fig.7-2