User's Manual

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have nished.
40
Doors
6.1 To Remove the Grill Door
Remove the left-hand side panel (see 1.2). Remove the plinth
(4 screws) and the central vertical cover (5screws). Remove
the 2 countersunk screws (1 each side) securing the grill hinge
arms to the front of the grill chamber.
Note: The arms are spring tensioned. Carefully remove the grill
door. Retain the gaskets.
Reassemble in the reverse order, making sure that the gasket
is tted between the hinge arm and the front of the grill
chamber.
6.2 To Replace the Main Oven Door
Open the oven door. Support the door and loosen the 2
screws securing the upper hinge and gasket to the cooker
front (Fig. 10.9).

The door is heavy, so take care.
Support the door and remove the screw nearest the hinge
pin (Fig. 10.10). Swing the hinge up and away from the
door hinge pin. Lift the door away from the lower hinge and
remove.
Reassemble in reverse order.
6.3 To Adjust the Main Oven Door Angle
The bottom hinge of the main oven door can be adjusted to
alter the angle of the door (Fig. 10.11). Loosen the bottom
hinge xing screws and use the notch and a at bladed
screwdriver to move the position of the hinge to set the hinge
position
(Fig. 10.12).
Retighten the hinge screws.
6.4 To Replace the Main Oven Door Outer Panel
Move the cooker forwards to gain access to the sides.
Open the main oven door slightly and remove the 4front
panel xing screws from the door sides (2 each side), (Fig.
10.13). Carefully lift o the outer door panel.
Remove the door handle from the panel by unscrewing the 2
retaining nuts.
Fit the door handle to the new panel.
Fit the panel to the door. Reassemble in reverse order.
6.5 To Change the Main Oven Door Latch
Remove the main oven door outer panel (see 6.4). Remove
screws ‘B’, which hold the latch assembly to the inner door
panel (Fig. 10.14). Fit the new catch and reassemble in reverse
order. Check the door operation.
6.6 To Adjust the Main Oven Door Catch Keep
Open the main oven door, slacken o the locknut at the base
of the keep, and screw in or out as required until the required
t is obtained. Retighten the locking nut
(Fig. 10.15).
ArtNo.320-0002a Proplus oven door side screws
ArtNo.320-0006 Oven door hinge adjustment 1
ArtNo.320-0007 Oven door hinge adjustment 2
Eect of hinge adjustment – exagerrated for clarity
Centreline of hinge pin
Oven door omitted for clarity
ArtNo.320-0003 Oven door latch
B
ArtNo.320-0004 Oven door keep
ArtNo.320-0001 Door hinges
1
ArtNo.320-0001 Door hinges
2
Fig. 10.9
Fig. 10.14
Fig. 10.10
Fig. 10.15
Fig. 10.11
Fig. 10.12
Fig. 10.13