User Manual
Table Of Contents
- 1Introduction
- 2Security
- 2.1General information
- 2.2Exposure to RF energy
- 2.3Efficient modem operation
- 2.4Antenna care and replacement
- 2.5Driving
- 2.6Electronic devices
- 2.7Vehicle electronic equipment
- 2.8Medical electronic equipment
- 2.9Aircraft
- 2.10Children
- 2.11Blasting areas
- 2.12Potentially explosive atmospheres
- 2.13Non-ionizing radiation
- 3Safety standards
- 4Technical data
- 5STEPPIII application interface
- 6Hardware Interfaces
- 7Housing
- 8STEPPII-Mounting cradle
- 9RF Exposures
- 10Appendix
STEPPIII Hardware description Version 1.0.0
6.1.2.3 Outputs (pin 5, 7, 9, 11)
The STEPPIII supports four outputs. These can be set remotely by the server
application. The figures below show the schematic of possible output
connections. Each output can be directly connected to a LED, Relay etc.,
which needs no more than 100 mA. The figures below show the schematic of
possible output connections.
Figure 8: Connection example 1 for an output (Relay, OUT2)
Figure 9: Connection example 2 for an output (LED, OUT3)
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 26