Operating instructions

After use

Dust bag

• Release both canister clips and remove motor head from the

canister by means of the carrying handle and set on side.

• Take off the textile filter (17).

• Carefully push the full dust bag sufficiently far back to expose

the socket inside.

• Now pull the bag upwards out of the canister and dispose of

with the household refuse.

• Pull the reinforced opening of the new dust bag over the

connecting socket by turning it slightly.

• Place the ends of the dust bag against the inner wall of the

canister.

• Reinsert the textile filter (17).

• Reinstall motor head and fasten the retaining clips.

H.E.P.A. filter

Change the H.E.P.A. filter at least after approx. 6 months or if it

is exceptionally dirty.

• Open the exhaust air grid, remove the old H.E.P.A. filter and

insert the new one.

• Insert the exhaust air grid again so that it fits precisely.

Motor protection filter /

foam filter

ATTENTION!

Clean or, if necessary, replace the motor protection filter / foam

filter on a regular basis.

• Release both canister clips and remove motor head from the

canister by means of the carrying handle.

• Set motor head on the table.

• Pull the dirty motor protection filter / foam filter carefully off

the float valve housing.

• The motor protection filter / foam filter can be cleaned in a

warm soapy solution. Then allow to dry thoroughly before re-

installing.

• Push the cleaned resp. new motor protection filter / foam fil-

ter on the float housing as far as it will go.

• Reinstall motor head and fasten the retaining clips.

- 22

21 -