Operation Manual

• Beard, moustache or sideburn hairs should be dry. Avoid

using lotions before using your groomer.

• Be certain that the hair length attachment is at the desired

setting. When first using, you may want to begin on the

highest setting (longest hair) to prevent trimming off too

much hair initially.

• Comb hairs outward so they are at their maximum height

and facing in the same direction.

Before using your

groomer

• Slide the on/off switch forwards or back wards to switch the

unit on or off.

• Clean the trimmer after each use as described in the chapter

“cleaning”.

Switching the

trimmer on and off

Place the ear&nose trimmer attachment top of the body by

turning right side.

Using Ear&Nose

Trimmer Attachment

Inserting The Battery Your clipper requires 1 “AA” alkaline battery.

1. To open the battery compartment, turn the base of the unit

approximately 1cm counter – clockwise (to the left ) and pull

it off.

2. Insert 1 “AA” battery into the unit, positive end first.

3. Replace the base and turn it 1cm clockwise (to the right) to

lock it into place.

Battery cautions • Use of non-alkaline batteries will impair the unit’s operating

performance.

• Remove batteries if the unit is not in use for long periods.

• To prevent battery corrosion, the unit should be stored in a

dry environment.

• Do not use rechargeable batteries with this appliance. The

lower voltage in rechargeable batteries impairs the perfor-

mance of the cutting unit.

USAGE