Datasheet

3 www.fairchildsemi.com
NC7WB3125
Absolute Maximum Ratings(Note 1)
Recommended Operating
Conditions
(Note 3)
Note 1: The “Absolute Maximum Ratings” are those values beyond which the safety
of the device cannot be guaranteed. The device should not be operated at these lim-
its. The parametric values defined in the Electrical Characteristics tables are not
guaranteed at the absolute maximum ratings. The “Recommended Operating Condi-
tions” table will define the conditions for actual device operation.
Note 2: The input and output negative voltage ratings may be exceeded if the input
and output diode current ratings are observed.
Note 3: Unused logic inputs must be held HIGH or LOW. They may not float.
DC Electrical Characteristics
Note 4: Measured by the voltage drop between A and B pins at the indicated current through the switch. On Resistance is determined by the lower of the
voltages on the two (A or B) pins.
Note 5: Per TTL driven input (V
IN
3.4V, control input only). A and B pins do not contribute to I
CC
.
Supply Voltage (V
CC
) 0.5V to 7.0V
DC Switch Voltage (V
S
) 0.5V to 7.0V
DC Output Voltage (V
IN
) (Note 2) 0.5V to 7.0V
DC Input Diode Current
(I
IK
) V
IN
0V 50 mA
DC Output (I
OUT
) Current 128 mA
DC V
CC
or Ground Current
(I
CC
/I
GND
) 100 mA
Storage Temperature Range (T
STG
) 65 C to 150 C
Junction Temperature under Bias (T
J
) 150 C
Junction Lead Temperature (T
L
)
(Soldering, 10 Seconds)
260 C
Power Dissipation (P
D
) @ 85 C 250 mW
Supply Operating (V
CC
) 4.0V to 5.5V
Control Input Voltage (V
IN
)0V to 5.5V
Switch Input Voltage (V
IN
)0V to 5.5V
Output Voltage (V
OUT
)0V to 5.5V
Operating Temperature (T
A
) 40 C to 85 C
Input Rise and Fall Time (t
r
, t
f
)
Switch Control Input 0 ns/V to 5 ns
Switch I/O 0 ns/V to DC
Thermal Resistance (
JA
) 250 C/W
Symbol Parameter
V
CC
T
A
40 C to 85 C
Units Conditions
(V) Min Typ Max
V
IK
Clamp Diode Voltage 4.5 1.2 V I
IN
18 mA
V
IH
HIGH Level Input Voltage 4.0 to 5.5 2.0 V
V
IL
LOW Level Input Voltage 4.0 to 5.5 0.8 V
V
OH
HIGH Level Output Voltage 4.0 to 5.5 See Figure 3 V V
IN
V
CC
I
IN
Input Leakage Current 5.5 1.0 A0 V
IN
5.5V
I
OFF
Switch OFF Leakage Current 5.5 1.0 A0 A, B V
CC
R
ON
Switch On Resistance 4.5 3.0 7.0 V
IN
0V, I
IN
64 mA
(Note 4) 4.5 3.0 7.0 V
IN
0V, I
IN
30 mA
4.5 6.0 15.0 V
IN
2.4V, I
IN
15 mA
4.0 10.0 20.0 V
IN
2.4V, I
IN
15 mA
I
CC
Quiescent Supply Current 5.5 3.0 AV
IN
V
CC
or GND
I
OUT
0
I
CC
Increase in I
CC
per Input (Note 5) 5.5 1.0 2.5 mA V
IN
3.4V, One OE Input only,
Other OE V
CC