Datasheet
© 2002 Fairchild Semiconductor Corporation www.fairchildsemi.com
NC7SV08 • Rev. 1.0.5 4
NC7SV08 — TinyLogic
®
ULP-A 2-Input AND Gate
Absolute Maximum Ratings
Stresses exceeding the absolute maximum ratings may damage the device. The device may not function or be
operable above the recommended operating conditions and stressing the parts to these levels is not recommended.
In addition, extended exposure to stresses above the recommended operating conditions may affect device reliability.
The absolute maximum ratings are stress ratings only.
Symbol Parameter Min. Max. Unit
V
CC
Supply Voltage -0.5 4.6 V
V
IN
DC Input Voltage -0.5 4.6 V
V
OUT
DC Output Voltage
HIGH or LOW State
(3)
-0.5 V
CC
+ 0.5
V
V
CC
= 0 V -0.5 4.6
I
IK
DC Input Diode Current V
IN
< 0 V -50 mA
I
OK
DC Output Diode Current
V
OUT
< 0 V -50
mA
V
OUT
> V
CC
+50
I
OH/
I
OL
DC Output Source/Sink Current ±50 mA
I
CC
or I
GND
DC V
CC
or Ground Current per Supply Pin ±50 mA
T
STG
Storage Temperature Range -65 +150 °C
T
J
Junction Temperature Under Bias +150 °C
T
L
Junction Lead Temperature, Soldering 10 Seconds +260 °C
P
D
Power Dissipation at +85°C
SC70-5 150
mW MicroPak-6 130
MicroPak2-6 120
ESD
Human Body Model, JEDEC:JESD22-A114 4000
V
Charge Device Model, JEDEC:JESD22-C101 2000
Note:
3. IO absolute maximum rating must be observed.
Recommended Operating Conditions
The Recommended Operating Conditions table defines the conditions for actual device operation. Recommended
operating conditions are specified to ensure optimal performance to the datasheet specifications. Fairchild does not
recommend exceeding them or designing to Absolute Maximum Ratings.
Symbol Parameter Conditions Min. Max. Unit
V
CC
Supply Voltage 0.9 3.6 V
V
IN
Input Voltage 0 3.6 V
V
OUT
Output Voltage
V
CC
= 0 V 0 3.6
V
HIGH or LOW State 0 V
CC
I
OH
/I
OL
Output Current in I
OH
/I
OL
V
CC
= 3.0 V to 3.6 V ±24
mA
V
CC
= 2.3 V to 3.6 V ±18
V
CC
= 1.65 V to 1.95 V ±6
V
CC
= 1.4 V to 1.6 V ±4
V
CC
= 1.1 V to 1.3 V ±2
V
CC
= 0.9 V ±0.1
T
A
Operating Temperature, Free Air -40 +85 °C
Δt/ΔV
Minimum Input Edge Rate V
IN
= 0.8 V to 2.0, V
CC
= 3.0 V 10 ns/V
θ
JA
Thermal Resistance
SC70-5 425
°C/W
MicroPak-6 500
MicroPak2-6 560
Note:
4. Unused inputs must be held HIGH or LOW. They may not float.