Owner's manual

Section 3: Access Terminal Screens Defined

01/13 50 51299 Rev. 1

3.2.11. Traffic Control Setup, Continued

SCREEN PORTION 1 General Setup –

Monitor:

• No Traffic – simple in and out weighing without need to stage scale devices.

• Inbound Traffic – Enables inbound Traffic Devices, or section only.

• Outbound Traffic – Enables outbound Traffic Devices, or section only.

• In & Outbound Traffic – Enables Outbound and Inbound Traffic

or both and

Loading: Determines when the system will guide and check for vehicle on the scale.

• No Vehicle Loading

• Before Transaction Starts- Always use when Access Unit is located on Scale

• Before Getting the Weight- When Access Unit is positioned before scale

Give Preference: Used when two terminals are controlling traffic across the scale.

Each terminal is controlling traffic from one direction (inbound / outbound). Checking

one of the two will give one of the terminals a preference.

Deny Other Traffic: Generally both inbound and outbound transactions can be done

at the same Access Unit, when enabled this is not allowed. The inbound unit can

only start a transaction and the outbound can only complete it, otherwise a service

denied error will appear.