Owner's manual

Section 3: Programming
01/12 45 50647 Rev. 9
3.5.1. I/O MENU DESCRIPTIONS, CONTINUED
PROMPT CHOICE(S)
SPALrt
 Used for ALARM purposes.
 In the SoLo mode only Relay 8 is used, for both the LOW and HIGH
alarm.
 In the paired mode, Relays 4 and 8 are used.
 The setpoint-relay will be active when the GROSS weight is equal to or
below the programmed LOW ALARM weight value or equal to or
above the programmed HIGH ALARM weight value.
─ The following applies to either of the Setpoint Batch modes, whenever the
weight on the scale is below or above the Alert Value, and the Alert is
enabled. The alert relay(s) toggle On/Off when the following occurs.
 The front panel keys are pressed.
 The instrument comes out of its Sleep mode.
The SPALrt targets are only programmable in the IO Port B Menu.
 The SPALrt may be used with all other setpoint modes except whenever
four (4) paired setpoints are programmed.
 If SPALrt is enables in conjunction with any other setpoint option, the
instrument prompts for Alarm low wgt, causing an Alarm high wgt.
 Alarm IO must be set to a value other than zero.