Owner's manual

Section 3: Programming
01/12 44 50647 Rev. 9
3.5.1. I/O MENU DESCRIPTIONS, CONTINUED
TARGET MENU
PROMPT CHOICE(S)
tArgEt
 Used for programming weight values associated with setpoint-relays.
 Target 1 = relay 1 and Target 2 = relay 2, through rest of programmed
setpoints.
 The number of targets will vary depending on number selected during
initial setup. Modifications should be performed with caution.
 The Setpoint mode determines the target function, and targets should
be programmed accordingly.
SEtPnt MODE
Target Assignment
PROMPT CHOICE(S)
SPCont
 Target 1 thru X (where X is the total number of setpoints) are the
programmed number of setpoint relays.
 Single-value relays that energize when their assigned weight value is
reached or exceeded.
 These relays, as a group, are manually controlled by the START and
STOP front panel keys.
 No Autoprint available in this mode.
SPChEC
 In the Check Weigh mode, Target 1 is the UNDER range setpoint-
Relay 1.
 It is on-active if the weight is equal to or below its assigned weight
value.
 Target 2 is the OVER range setpoint-Relay 2.
 It is Active when the weight is equal to or above its assigned weight
value.
 The ACCEPT range is the weight between UNDER and OVER.
 It is selected to operate either the Gross or Net modes.
NOTE:
 The legends for UNDER, ACCEPT, and OVER show on the large display
when its associated weight value is active.
 There is not a relay output for the ACCEPT range.
 When using the
SPCont or SPChEC modes the relays respond to the
absolute value displayed (+/-) in the Gross mode and to the positive value
displayed in the
Net mode.