Owner's manual

Section 3: Programming
01/12 32 50647 Rev. 9
3.2. TARGET MENU DESCRIPTION
This area is for the numeric entry of target
weights by the operator.
─ No sub menu selections are
available.
─ Note that the Status Display
shows the current setpoint being
programmed.
1. Use the SCROLL keys to select the
setpoint to be programmed.
2. Key in the desired target weight using
the numeric keypad including the
decimal point, if applicable.
3. Press the ENTER key.
4. When all applicable setpoints have
been programmed, press the
B/G NET key.
─ The SToRE displays.
5a. If the ENTER key is pressed, the display will indicate SToRED momentarily and
then TARGET. Pressing B/G NET again will exit to the weigh screen.
5b. If the SCROLL key is depressed, it will toggle between SToRE and CANCEL.
─ The CANCEL prompt gives the operator the option of exiting without saving
changes.
6. Select CANCEL and press the ENTER key, the display will show TARGET.
7. Pressing the B/G NET key will exit to the weigh screen.
io
CAL
tArGEt
inFo
CAnnEd
ConFig
xxxxxx
tAr
g
Et 1
tAr
g
Et 2
xxxxxx
xxxxxx
xxxxxx
xxxxxx
xxxxxx
xxxxxx
xxxxxx
tAr
g
Et 3
tAr
g
Et 4
tAr
g
Et 5
tAr
g
Et 6
tAr
g
Et 7
tAr
g
Et 8