User Manual

02/13 22 51315 Rev. 1
Section 3: Programming
3.1. POWERING ON AND OFF THE FB2255
• To turn on the FB2255, press and hold the ON / OFF Key for two (2) seconds.
– The Instrument will display “888888”, then a “1234567890” character display
moving from right to left, followed by the revision of software.
– Upon completing the warm-up, the FB2255 will display the actual weight on
the scale.
• To turn off the FB2255, press and hold the ON / OFF Key for two (2) seconds.
3.2. ENTERING PROGRAM MODE
Unscrew the plastic lockout plug located at the
rear of the enclosure and press the Internal
Program Switch
.
NOTE: Repeatedly pressing the program switch will cycle through Set-up,
Config, APP, CAL, and back to the Weigh Mode.
If the program parameters are outside of set limits, the
Program Defaults are
loaded/reloaded at power-up.
3.2. SAVING PROGRAM CHANGES
• Program changes are automatically saved upon exiting the Program Mode.
• Press the PROGRAM SWITCH to exit to the Weigh Mode.
3.3. SETUP MENU PROGRAMMING PARAMETERS
1. Press and hold the Internal Program Switch until SEtUP displays.
2. Use the right arrow key to scroll through each menu item.
3. Program the Set Time, Set Date and Port 1 functions, as shown in the following
information.
Internal
Program
Switch