User Manual

Section 2: Assembly
02/13 15 51315 Rev. 1
2.3. MOUNTING BRACKET KIT ASSEMBLY,
CONTINUED
5. Tighten the pillar rod nuts using an adjustable wrench
─ Do not to touch the load cell while tightening each one.
6. On the bottom back-side of the scale’s base, lift up the
lever end while placing the hook under the lever's pivot.
─ Do this while holding the hook on top of the pull rod.
7. Inserting the “S” hook:
a. Insert the “S” hook (#3) through the eyelet of the load
cell linkage cable adapter.
b. Slide the “S” hook bottom into the top hook on the
Steelyard rod.