User Manual

08/12 13 51300 Rev. 1
Section 3: Installation
3.1. TOOLS REQUIRED
 #1 or Small Slotted Screwdriver
 #2 Phillips Screwdriver
 10" Adjustable Wrench
 Pliers
3.2. WHEEL AND PILLAR ASSEMBLY
6. Set the Scale Base Assembly (#4) sideways on the floor.
7. Insert a Cotter Pin (
#17) through the small hole in one end of the First Axle
(#19).
8. Place a Flat Washer (#18) and a Wheel (#16) onto the open end of the axle.
9. Insert the axle's other end through both holes in the base.
10. Place the Second Wheel (#16) onto the axle.
11. Place a Flat Washer (#18) over the axle, and then insert a cotter pin (#17)
through the axle’s small hole.
12. Repeat steps 2-6 for the second axle.
13. With the Scale Base Assembly (#4) in an upside-down position, center the axles
in the base.
14. Insert the Locking Screws (#15) into the tapped holes in the bottom of the base,
tightening the axle into place with the screws.
– Directly under the axle holes.
15. Secure the Lock Nuts (#14).
NOTE: See the diagram on the following page to identify parts in these assembly
instructions.