Manual

25
(4) Controller stand installation
➀ After connecting the splitter cord that comes with the unit to the signal relay cable (6-2 Finishing (3)), remove it from
the base through the conduit sheath and connect it to the controller stand itself.
➁ Press the controller stand into the base.
Controller
stand
Connector
Front
➁ Tighten the included Allen head set screw in the hole in the back of the controller stand. After turning the screw until it
stops, turn it 180 to 360° backward from where it stopped turning.
❈ Please be careful not to let the screw protrude when doing so.
Allen head set screw
Front
Front
Always turn back the screw.
• Neglecting to do so could keep the remote controller stand from moving back and forth.
Always do this