User Manual

To the installer

• Be sure to provide the customer with the Installation manual.

• Fill out the necessary warranty information on the back off the Owner manual (for AirBaths).

ABF Installation without access under the floor (continued)

Install Bathtub

• Apply a generous bead of adhesive or silicone (such as GE 5040 Silicone II) to the bottom of the

tub supports.

• Apply a bead of tub and tile caulk (such as GE 7000 Silicone II Paintable Silicone) around the

edge of the base.

• Carefully set the tub into position over the drain body.

• From inside the tub thread on the drain body top. Do not over tighten.

• Be sure the tub is resting on the bottom supports and not the acrylic.

Complete Installation

• Fill the tub with water to the overflow and drain the tub while inspecting the waste connections below the floor for leaks.

• With the bathtub now in place wipe off any excess tub and tile caulk around the bottom edge of the bathtub where it meets the

floor.

• Run a bead of tub and tile caulk around the bottom edge of the bathtub where it meets the floor. Wipe off any excess caulk with a

wet cloth.

• Replace the stopper.