User Manual

15
Test Locking Function
Make sure that the bolt extends as shown in the “correct” drawing below.
OR
Incorrect
Correct
If bolt does not extend, remove
lock from door. Follow steps5-10 to
reinstall lock.
Pay special attention to step 7. The
cam orientation is the most likely
source of a problem.
a. Press
b. Rotate turn towards
door edge until bolt extends
a
16
Test Unlocking Function
Press (four numbers)
Programming Code XXXXXX
User Code A xxxx
User Code B xxxx
S/N x-xxxxxxxx
Model BE369
on keypad
Green flash = unlock
Rotate turn away from door
edge and bolt will retract
Follow the directions on document to continue setup.
!
Test with door open to
avoid being locked out!
!
Test with door open to
avoid being locked out!
17
This portion of the setup is complete.
Document 2 is located at part2.schlage.com.