BE369 Deadbolt Installation Instructions Important Information Alternate Faceplate Lock Programming Code O six (6) digits User Code A four (4) digits User Code B four (4) digits Web Support: part2.schlage.
1 Locate Programming Code and Preset User Codes The programming code and the preset user codes are printed on the yellow stickers located on the back of the keypad and on the installation sheet that came in the box. Write these codes in the space provided on the first page.
Check Backset The backset is the distance from the edge of the door to the center of the hole through which the lock is installed. This lock will fit either a 2C\,” backset or a 2C\v” backset. The bolt is preset to fit a 2C\,” backset. If your backset is not 2C\,”, you need to adjust your bolt by rotating it counterclockwise. 2³⁄₈” (60 mm) 2³⁄₄” (70 mm) OR 2 ³⁄₄ 4 4 Choose Faceplate Choose the faceplate that most matches your existing door preparation.
5 Install Bolt The word “TOP” should be facing upward as shown below. Top Top OR (2) 6 Install the Keypad Feed the cable over the top of the bolt assembly as shown below. Then slide the tailpiece through the correct hole as shown below.
7 Check the Cam on the Baseplate Locate the cam on the baseplate. This cam has a small arrow on it that should point to the arrow that is printed on the casing above the cam, like picture “a” below. If the cam is oriented sideways, like the picture “b”, rotate the cam until the arrows match. a b Cam 8 Install the Baseplate Feed the cable through the hole as shown below. DO NOT connect the cable at this time. Then slide the baseplate onto the tailpiece and press against the door.
9 Secure the Baseplate to Door Use the two screws shown to secure the baseplate to the door. (2) 10 Connect the Cable Snap the connectors together. Tuck them into the open space in the baseplate. Make sure no wires will be pinched when the cover is installed.
11 Install the Batteries There are two sets of batteries. Install both the 9V and the AA batteries. Remove screw here to access AA battery tray. b c 12 Install the Cover Place the cover against the door and secure using the two screws. You may need to rotate the thumbturn to the proper position, shown below. Note that the top screw is longer and painted black. ! Tuck wires into open space on baseplate. Be careful not to pinch any wires between cover and baseplate.
13 Prepare the Frame for the Strike Place the reinforcement strike inside the strike hole and mark the 4 hole locations. Drill them as shown. If the strike cut-out has not been prepared in the frame, see the “Strike cut-out specifications” box. Drill 4 holes Mark 4 holes 1" (25 mm) Strike cut-out specifications 1" (25 mm) 2³⁄₄" (70 mm) 1¹⁄₂" (38 mm) ¹⁄₈" (3 mm) 1¹⁄₈" (29 mm) 14 Install the Strike Install for maximum security.
15 Test Locking Function Make sure that the bolt extends as shown in the “correct” drawing below. ! Test with door open to avoid being locked out! a. Press b. Rotate turn towards door edge until bolt extends Correct a OR Incorrect 16 If bolt does not extend, remove lock from door. Follow steps5-10 to reinstall lock. Pay special attention to step 7. The cam orientation is the most likely source of a problem.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications to this equipment not expressly approved by Schlage could void the user’s authority to operate the equipment.
