Installation Instructions / Warranty Metris 31436XX1 Talis 32313XX1 Focus 31732XX1 Metris 31446XX1 Talis 32314XX1 Focus 31733XX1
Trim, 3- and 4-Hole Roman Tub Sets Metris Focus Talis 3-Hole 4-Hole 31436001 31446001 31732001 31733001 32313XX1 32314XX1 Installation Considerations The 4-Hole Roman Tub Set trim kits require rough 06646000. The 3-Hole trim kits require rough 06607000. The rough valves are not included. The rough must be installed and the mounting surface complete and made watertight before installation of this trim kit. The elbow for the handshower incorporates a check valve to prevent back siphonage.
2313XX1 32314XX1 31732XX1 31733XX1
Installation - 3-Hole Trim Kits If you are using a 4-Hole set, please turn to page 6 Install the Handles Remove the plaster shields from the hot and cold valves and the spout tee. Install the handle escutcheons. Install the white plastic snap connectors and the screws. Push the handle down firmly over the snap connectors. Assemble the Spout Remove the brass plug from the tee.
Push the spout sealing ring firmly into the spout tee. Install the spout escutcheon. Press the spout over the spout tee. Install and tighten the set screw with a 3 mm Allen wrench. CAUTION: do not overtighten the set screw or the o-rings on the diverter will deform, which will cause a leak. Turn on the water and check all connections for leaks.
Installation - 4-Hole Trim Kits Install the Handles Remove the plaster shields from the hot and cold valves and the spout tee. Install the escutcheons. Install the white plastic snap connectors and screws. Push the handle down firmly over the snap connector. Assemble the Diverter and Spout Remove the brass plug from the tee.
Press the diverter assembly firmly into the spout tee until it is fully seated. Turn the guide bushing so that the slot faces the rear of the spout. Install the spout escutcheon. Firmly press the spout over the tee and diverter. Tighten the set screw with the included 3 mm Allen wrench. CAUTION: do not overtighten the set screw or the o-rings on the diverter will deform, which will cause a leak. Install the pull rod. The threaded end of the pull rod must go into the hole in the pin.
Install the Handshower Holder Escutcheon and Handshower (4-Hole version only) Remove the plaster shield from the handshower holder. Pull out on the handshower hose. Screw the handshower holder escutcheon into place. Install the elbow. Place a black rubber hose washer in the elbow. Screw the handshower into the elbow. Guide the handshower into the holder.
Scale Removal The Raindance Air 1-jet handshower incorporates the RubitTM cleaning system. If scale deposits are noticed in the spray channels, turn the water on lightly and rub the spray channels with a finger or a sponge. If scale deposits are noticed on the spray face, pour about 3/4” of a commercial scale remover, such as LimeAwayTM or CLRTM ,into a shallow dish. Dilute the remover according to the label instructions.
Replacement Parts 3-Hole Roman Tub Sets 11 1 2 2 3 12 3 4 13 4 14 Metris Talis 1 2 3 4 Focus 10
Replacement Parts 4-Hole Roman Tub Sets 6 1 7 2 12 10 8 9 13 4 5 14 Metris 6 6 1 2 2 4 4 5 5 Talis Focus 11
Replacement Parts (see pages 10 & 11) 1 2 3 4 5 6 7 8 9 10 11 12 13 14 aerator 13956XX0 spout escutcheon 97779XX0 sealing ring 88512000 snap connector 94184000 diverter 96775000 diverter knob 98707XX0 handshower 28509XX1 check valve 94074000 handshower escutcheon 06778XX0 elbow 28071XX1 spout 31095XX0 hot handle 31096XX0 cold handle 31097XX0 handle escutcheon 31098XX0 XX = finish 00 = chrome 82 = brushed nickel 12
Cleaning Recommendation for Hansgrohe Products Modern sanitary faucetry and shower fixtures consist of very different materials to comply with the needs of the market with regard to design and functionality. To avoid damage and returns, it is necessary to consider certain points when cleaning: Cleaning materials for faucets and shower products: Acids are necessary ingredients of cleaning materials for removing lime.
Limited Lifetime Consumer Warranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or Canada. WHO IS COVERED BY THE WARRANTY This warranty extends to the original consumer purchaser only. This warranty is non-transferable.
EXCLUSIONS AND LIMITATIONS REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT.
www.hansgrohe-USA.com US - Installation Instructions • Part No. 90597501 • Revised 05/2007 Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004 Tel.
