User guide

5
27410XX1 Installation Instructions
• The wall should be reinforced at the mounting
point. Position the mounting piece over the 1/2" nipple.
Mark the positions for four screw holes. Put the mounting
piece away in a safe location.
• Drill the screw holes with a 6 mm drill bit suitable for the
wall surface (1,2). Install the anchors (3). Seal the wall
around the anchors with a waterproof bathroom sealant.
• Seal the wall around the nipple with a waterproof
bathroom sealant (1). Wrap the threads on the nipple with
Teflon
®
thread tape (2). Install the mounting piece with a
17 mm wrench (3).
• Secure the mounting piece to the wall with the four screws
(1). Position the shower arm over the mounting piece (2).
Tighten the set screw with a 2.5 mm allen wrench (3).
Thread the escutcheon over the mounting piece by turning
it clockwise (4).
• Install the showerhead. Be sure that it is screwed fully to
the shower arm.
• Secure the showerhead with the hollow set screws. (allen
wrench = 2 mm)