Owner's manual

6
27410001 Installation Instructions
Position the mounting piece over the nipple. Mark the
positions for four screw holes. Put the mounting piece in
a safe place.
Drill the screw holes with a 6 mm drill bit suitable for the
wall surface (1,2). Install the anchors (3). Seal the wall
around the anchors with a waterproof bathroom sealant.
Seal the wall around the nipple with a waterproof ba-
throom sealant (1). Wrap the threads on the nipple with
Teflon
®
thread tape (2). Install the mounting piece with a
17 mm wrench (3).
Caution: do not drill into water line!
The showerhead and arm assembly weighs
approximately 20 lbs. The enclosed mounting
hardware is suitable for a solid surface only.