Installation Instructions / Warranty Raindance Air Royale 28420001 Ceiling Arm 27418001 Shower Arm 27410001
Suggested Layouts 28420001 27410001 27418001 Two-feature installation with Ecostat thermostatic mixer and Trio diverter. Installation Considerations: The 27418001 shower arm requires a 1/2" male threaded nipple, recessed 3/8" behind the finished surface of the ceiling. The 27410001 shower arm requires 1/2" male threaded nipple, extending 5/8" outside the surface of the finished wall. Hansgrohe recommends that the Raindance Air Royale showerhead be installed with the Ecostat thermostatic mixing valve.
27418001 Installation Instructions: Install a 1/2" male threaded nipple, recessed 3/8" behind the surface of the finished ceiling. Using the mounting plate as a template, mark the positions for four screw holes. Put the mounting plate in a safe place. The showerhead and arm assembly weighs approximately 20 lbs. The enclosed mounting hardware is suitable for a solid surface only. Drill the holes with a 6mm bit suitable for the ceiling surface.
Install the anchors. Seal around the nipple and the elbows with a waterproof bathroom sealant suitable for the ceiling surface. Install the mounting plate. 12 mm Secure the mounting plate to the ceiling with four screws.
Install the trim plate and the arm. Install the showerhead. Caution: the showerhead is heavy. Damage to the showerhead or to the shower enclosure caused by dropping the showerhead is not covered under the Hansgrohe warranty. Tighten the safety screws with a 2 mm Allen wrench.
27410001 Installation Instructions Position the mounting piece over the nipple. Mark the positions for four screw holes. Put the mounting piece in a safe place. Caution: do not drill into water line! Drill the screw holes with a 6 mm drill bit suitable for the wall surface (1,2). Install the anchors (3). Seal the wall around the anchors with a waterproof bathroom sealant. The showerhead and arm assembly weighs approximately 20 lbs. The enclosed mounting hardware is suitable for a solid surface only.
Secure the mounting piece to the wall with the four screws (1). Position the shower arm over the mounting piece (2). Tighten the set screw with a 2.5 mm allen wrench (3). Thread the escutcheon over the mounting piece by turning it clockwise (4). Install the showerhead on the arm. Tighten the safety screws with a 2 mm Allen wrench.
Cleaning Instructions: The Raindance Air Royale showerhead uses the RubitTM self-cleaning system. The spray channels are lined with a substance that resists scale buildup. If scale deposits are noticed in the spray channels, turn the water on lightly and rub across them with a finger or a sponge to dislodge the deposits. If scale builds up on the spray face, pour about 3/4" of a commercial scale remover, such as Lime-AwayTM or CLRTM into a shallow dish.
Cleaning Recommendation for Hansgrohe Products Modern faucetry and shower products utilize a combination of materials to comply with the needs of the market with regard to design and functionality. To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment is not covered under the Hansgrohe warranty. Cleaning Materials for Faucets and Showers • • • • To remove lime scale, use only products made specifically for that purpose.
Limited Lifetime Consumer Warranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or Canada. WHO IS COVERED BY THE WARRANTY This warranty extends to the original consumer purchaser only. WHAT IS COVERED BY THE WARRANTY This warranty covers only your Hansgrohe manufactured product.
EXCLUSIONS AND LIMITATIONS REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT.
www.hansgrohe-USA.com US-Installation • Part No. 90580103 • Revised 03/07 Hansgrohe, Inc.
