Installation Instructions / Warranty Massaud 18450001
Axor Massaud Free-Standing Tub Filler 18450001 Product Specification Max. incoming water pressure 145 psi Recommended water pressure 14.5 - 72 psi Max. incoming hot water temp. 176oF* Recommended incoming hot water temp 120oF - 140oF* Flow rate @ 44 psi 5.8 gpm Max. flow rate of handshower 2.5 gpm Requires rough valve 10452181 (not included) Protection against back siphonage provided by check valve *Know and follow all applicable local plumbing codes when setting the temperature on the water heater.
** **There must be at least 3/8” clearance between the top of the tub and the bottom of the handle. If there is less than 3/8” clearance, order extension 97686000 from your dealer. Installation Considerations Rough valve 10452181 must be installed. The finished floor surface must be complete and made watertight prior to installation of this tub filler. This unit is not anti-scald.
Installation Turn the water off at the main before beginning. Cut the plaster shield on the rough valve so that it is 3/8” above the surface of the finished floor. Remove the flush insert. Do not discard the screws. Position the tub filler over the rough. Turn it so that the spout faces in the correct direction. Make sure that the unit is plumb. Install the three screws included with the tub filler and the three screws reserved from the flush insert. Tighten the screws with an 8 mm Allen wrench.
Seal the floor around the tub filler with waterproof sealant. Lower the escutcheon to the floor. Place the black rubber hose washer in one end of the hose. Connect this end of the hose to the outlet port on the side of the tub filler. Place the screen washer in the other end of the hose. Connect this end of the hose to the handshower. Place the handshower in the holder. Set the high temperature limit stop, if required by local plumbing code (see page 6).
Re-set the High Temperature Limit Stop (optional) Close the drain OR cover it with a wash cloth. Use the included 4 mm Allen wrench to push the screw cover into the handle. Retrieve the screw cover when the handle is removed. Use the 4mm Allen wrench to loosen the handle screw 4 complete revolutions. Remove the handle and put it in a safe place. Remove the decorative nut cover and put it in a safe place. Remove the handle screw from the stem of the cartridge. Remove the high temperature limit stop.
User Instructions Pivot the lever upwards to turn the water on. Pivot it to the right for cooler water, to the left for warmer water. Pivot the lever downwards to turn the water off. Pull out on the diverter knob to divert the water to the handshower. When the water is turned off, the diverter will reset to the spout position. The handshower incorporates the RubitTM cleaning system. If scale deposits are noticed in the spray channels, rub across the channels with a finger or a sponge to dislodge them.
Replacement Parts 5 12 11 6 10 8 4 3 7 2 1.1 1 9 13 44 x 2.5 29 x 3 1 1.
Cleaning Recommendation for Hansgrohe Products Modern sanitary faucetry and shower fixtures consist of very different materials to comply with the needs of the market with regard to design and functionality. To avoid damage and returns, it is necessary to consider certain points when cleaning: Cleaning materials for faucets and shower products: Acids are necessary ingredients of cleaning materials for removing lime.
Limited Lifetime Consumer Warranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or Canada. WHO IS COVERED BY THE WARRANTY This warranty extends to the original consumer purchaser only. This warranty is non-transferable.
EXCLUSIONS AND LIMITATIONS REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT.
www.hansgrohe-USA.com US - Installation Instructions • Part No. 90414321 • Revised 03/2007 Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004 Tel.
