Installation Instructions / Warranty Massaud 18112001 Massaud 18115001
Axor Massaud 3-Hole Lavatory Mixer Trim with Short Spout 18112001 Axor Massaud 3-Hole Lavatory Mixer Trim with Long Spout 18115001 18112001 18115XX11 Product Specification Max. Flow Rate 2.2 gpm Max. incoming water pressure 145 psi Recommended water pressure 14.5 - 72 psi Max. hot water temperature 176o F* Recommended hot water temp 120oF - 140oF* No drain is included. Requires rough valve 18113181 (not included). Do not place more than 8 lbs on the spout.
Installation Remove the caps from the plaster shields on the rough valve (1). Cut the plaster shields so that they extend 1/16” outside the surface of the finished wall (2). Seal the wall around the plaster shields with waterproof sealant. Remove the plug from the spout outlet using a 17 mm socket wrench (1). Install the slip coupling on one of the the valves (2). Mark a point on the slip coupling 3/16” from the surface of the finished wall. Cut the slip coupling at that point (3).
Insert a measuring device in the spout outlet. Measure from the port on the rough to the end of the plaster shield. Record this measurement (X). Add 2” to X. Cut the spout connector so that it is X + 2” long. Wrap the threads on the spout connector with Teflon thread tape (1). Screw the spout connector into the spout port using a 12 mm Allen wrench (not included) (2). The spout connector should extend 1 3/16” outside the surface of the finished wall.
Make sure that the snap connectors are firmly screwed to the nuts. Place the handles over the snap connectors and press very firmly into place. Position the spout adapter and seal over the spout connector. Secure the adapter to the rough with the screws. Slide the spout into place over the adapter and connector(1). Tighten the top set screw with a 3 mm Allen wrench (included) (2). Tighten the bottom set screw (3).
Replacement Parts 18112001 10 8 11 12 1 3 6 5 4 2 1 2 3 4 5 6 7 8 9 10 11 12 handle color ring set snap connector nut handle escutcheon fixing set spout spout spray former spray former spout connector 16 x 2.
18115001 9 7 11 12 1 3 6 5 4 2
Cleaning Recommendation for Hansgrohe Products Modern sanitary faucetry and shower fixtures consist of very different materials to comply with the needs of the market with regard to design and functionality. To avoid damage and returns, it is necessary to consider certain points when cleaning: Cleaning materials for faucets and shower products: Acids are necessary ingredients of cleaning materials for removing lime.
Limited Lifetime Consumer Warranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or Canada. WHO IS COVERED BY THE WARRANTY This warranty extends to the original consumer purchaser only. This warranty is non-transferable.
EXCLUSIONS AND LIMITATIONS REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT.
www.hansgrohe-USA.com US - Installation Instructions • Part No. 90414221 • Revised 12/2006 Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004 Tel.
